TIGONIS Rust Remover RR 101

►Ease of application – Ready to use, easily applicable by brush
►Penetration & effect – effective rust removal even from areas difficult to reach and penetrate
►Economical – Cost effective because of good coverage.

1. SURFACE PREPARATION
In case of heavy rusting of steel reinforcement, M.S. pipelines, M.S. plates or any other M.S. surface, remove the loose rust by wire brushing, chipping, hammering or grinding so that majority of rust scale is removed.
2. APPLICATION
Apply Tigonis Rust Remover on affected surface by using cotton waste swab or by brush application. Leave the surface to react with Tigonis Rust Remover for at least 15 to 30 minutes.
The rusty surface will change its colour to original blackish steel; remove the same with cotton cloth.
Then remove the loose rust particles by scrubbing or simple dusting with the brush.
Wash the steel surface with water jet to remove the entire residue left on the bar, and clean with cotton cloth.
3. FINISH
When applied over corroded reinforcement steel, wash the surface with clean water before taking up further work of repairs.

Ensure the surface is clean, dry and free from all defective or poorly adhering material, dirt, grease,
wax, etc. Remove all loose or poorly adhering materials by rubbing down using emery paper and
thereafter wipe clean. Treat fungus affected area using proper Fungicidal Solution. Allow to react for
6-8 hrs. Apply a coat of TIONIS INTERIOR Cement Primer Water Thinnable followed by TIGONIS Wall Putty to make a uniform surface and again apply a coat of INTERIOR Cement Primer WT. Now apply 2-3 coats of TIGONIS Acrylic Distemper of desired Shade.